Menu
Your Cart

Meta Thin Pour by Metallography Supplies

Meta Thin Pour  by Metallography Supplies

Meta Thin Pour by Metallography Supplies

Meta Thin Pour

Meta Thin Pour - by Metallography Supplies a Metallography World Corporation

META THIN POUR LIGHT GREEN META THIN POUR LIGHT GREEN META THIN POUR LIGHT GREEN

Meta-Thin Pour 


META-THIN POUR is a two-component, addition cured, platinum-catalyzed, hydrophobic vinyl polysiloxane. Its two components are poured into a container and mixed to obtain a uniform mixture. It may be used to reproduce surface characteristics. It is able to reproduce surfaces down to submicron particles or scratches. It is cured at room temperature. However, warmer temperatures accelerate the setting time and cooler temperatures slow the setting time.

Final Color Light Green

META-THIN POUR Available Products


Trial Size Kit

(REP-MTP-KIT) META-Thin Pour 130ml trial kit


Standard Size Kits

(REP-MTP-01) META-Thin Pour 380ml kit

(REP-MTP-02) META-Thin Pour Case of 10 380ml kits

 

META-THIN POUR Available Products


Standard Size Kits

(REP-GTP-KIT1) META-Thin Pour Quick Dispense Cartridge System kit complete

(REP-GTP-KIT2) Combo Kit Quick Dispense Cartridge System kit

 

Thin Pour Physical Properties – Determined at 23°C (72°F) (Tested according to ISO 4823)
Base Paste – Appearance - Homogenous blue-colored runny paste, Filling loading approximately 25% silicon dioxide.

Catalyst Paste – Appearance - Homogeneous, yellow-colored runny paste, filling loading approximately 25% silicon dioxide.
Mixed Material – Appearance - Homogenous green-colored runny paste.

Mixing Time

  • 30 seconds, larger masses may take up to 60 seconds
  • Working time (prior to gelation) 4.0 - 4.5 minutes

Setting Time

  • 8 – 9 minutes. Varies with ambient temperature. Warmer temperatures accelerate the setting time. Cooler temperatures slow the setting time.

Compression Set (Recovery from deformation) – 0.5%.
Strain in Compression (A modified Modulus of Elasticity) – 6 - 7%.

Shore A30

Dimensional Change

  • After 24 hours - 0.50% Change (negative 0.50% change) this means it shrinks 0.50%
  • After 7 days - 0.50% Change (negative 0.50% change) this means it shrinks 0.50%

Tear Strength – 200 psi
Flash Point of the Polymers Used – 130°C (266°F)
Ignition Temperature of the Polymers Used – 70°C (878°F)


Fully set material may be autoclaved, but its dimensional stability may be compromised. If allowed to return to room temperature, it should return to the original shape.

Disinfection
Since material is hydrophobic, immersion in disinfectants is acceptable. The surface color may change due to the disinfectants used.

There is no product that matches the search criteria.